DIY PVC Clamp - Powerful Handmade site

DIY PVC Clamp

Sharing is caring!

Introduction: DIY PVC Clamp

DIY PVC Clamp

Show All Items

This used to be a feasibility learn about to peer if I may just make a low price clamp out of PVC pipe. I made this one out of “200 psi” as it used to be what I had at hand.

I latterly noticed an I’ble by way of somebody else making clamps by way of sawing it into bands and reducing slots within the bands. I can’t in finding his put up, so I can’t give him credit score for his concept, which impressed me to make this one. His clamps paintings excellent, except for they calls for two palms to tug them aside to clamp one thing. I sought after to peer if I may just upload handles so it may well be carried out with one hand. Now that I realize it’s imaginable, I will be able to be making some out of “Schedule 40” PVC pipe which has a thicker wall and is more potent.

The following is how I made this one.

Step 1: SUPPLIES AND TOOLS NEEDED

SUPPLIES AND TOOLS NEEDED
56ce77fd4936d470e50003d6.jpeg
56ce789b4fbade8d350003e5.jpeg
56ce7b044fbade8d350003f4.jpeg

Show All Items

SUPPLIES:

PVC pipe (I used 200 PSI; OD 1.25″, however I might suggest “Schedule 40”)

2 small items of flat plastic for handles to open the clamp

2 – 1/eight” pop rivets & washers

TOOLS:

Saw to chop PVC pipe (I used a chop noticed, nevertheless it may well be achieved with a hack noticed)

Grinder to form handles

Whitney hollow punch or electrical drill & 1/eight” bit

Pop riveter

Box knife to do away with sharp edges

Step 2: CUTTING & ASSEMBLY

CUTTING & ASSEMBLY
IMG_1817.JPG
IMG_1818.JPG
IMG_1820.JPG
IMG_1822.JPG

Show All Items

This is all lovely simple.

Cut the pipe into bands & cut up every band

Shape the handles & scrape off sharp edges;

Punch the holes for rivets;

Install pop rivets.

They paintings excellent, so the next move is to make larger, more potent clamps out of two” Schedule 40 PVC..

Step three: Final Product

Final Product
IMG_1827.jpg

Show All Items

I made this one out of two.25″ pipe and three/eight” rods. It’s a lot more potent than the former one. Drilling the holes for the rods took some making plans, measuring, and staining to get the rod placement uniform.

Step four: How It Works

Show All Items

I plan on making a few dozen of this dimension with the rods for hand grips. This one used to be simple to make and can make a excellent addition to my equipment. You can not have too many clamps to make use of in metalworking or woodworking.

NOTE: I made a larger clamp the usage of four” pipe. It can also be observed right here: https://www.instructables.com/identification/Evolution-of-PVC-Clamp/

Facebook Comments

Other EXCITING Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

403 Forbidden

403 Forbidden


nginx
shares